E-1.0

Single line diagram for an electrical permit set

A permit one-line is not a sketch. It has to show the utility, the meter, the main disconnect, every panel, the feeders, and any solar, battery, or EV equipment — on an 11×17 sheet with room for the department's review stamp.

Drawn from the same inputs as the calc

PermitPak lays the diagram out from the panels and loads you already entered. The main breaker, bus ratings, and feeder sizes on E-1.0 are the same numbers as E-2.0 and E-3.0. If you change a panel, the one-line changes with it.

The sheet is generated from hand-designed layout templates, not a generic box-and-line dump. Service drop or underground, copper or aluminum, and the grounding electrode system are part of the drawing.

What reviewers mark up

Missing subpanels, a solar inverter that does not appear, or a main that does not match the calc are the usual redlines. Because the diagram is rebuilt from the project file, a correction is a revision note — not a redraw in CAD.

PermitPak is not an engineering firm. Documents are not PE-stamped. Approval is not guaranteed.

Express-permit single-family jobs typically need no stamp. LADBS electrical plan check (new load over 400 A, equipment 600 A or more, solar/battery beyond standard plans, 3+ units, commercial) needs a California electrical engineer or, in limited cases, the installing C-10. Not legal advice.

PermitPak is not affiliated with or endorsed by LADBS, LADWP, SCE, or any city, county, or utility.