Commercial
Commercial electrical permit packet
A pizza shop and a big-box TI do not share a calc or a price. Commercial packets use Article 220 Parts III and IV from the occupancy type and floor area, then price the set from that same square footage. These sets are for C-10 contractors on work they install, or for licensed engineers who review and stamp.
Occupancy drives the demand
Office, retail, restaurant, warehouse, manufacturing, and school each pull a different volt-ampere density. Kitchen equipment, rooftop units, refrigeration, and elevators are added as nameplate loads on top of the general lighting and receptacle demand.
Pricing follows the floor area on the set: $149 under 2,500 sq ft, $299 to 9,999, $449 to 24,999, $598 at 25,000 and up.
Who commercial sets are for
Commercial sets are for C-10 contractors on work they install, or for licensed engineers who review and stamp. PermitPak prepares the electrical documents; it does not replace an engineer’s stamp and is not marketed as a substitute for a PE.
What ships in the packet
Every job produces six 11×17 sheets: cover, general electrical notes, single line diagram, panel schedules, electrical load calculation, and utility service data. The title block carries your company, license, and revision history.
A residential set is $89. Multifamily and commercial are priced from unit count and floor area. Corrections and re-downloads stay free on that job.
PermitPak is not an engineering firm. Documents are not PE-stamped. Approval is not guaranteed.
Express-permit single-family jobs typically need no stamp. LADBS electrical plan check (new load over 400 A, equipment 600 A or more, solar/battery beyond standard plans, 3+ units, commercial) needs a California electrical engineer or, in limited cases, the installing C-10. Not legal advice.
PermitPak is not affiliated with or endorsed by LADBS, LADWP, SCE, or any city, county, or utility.